When your Automatic door [ประตู อัต โน, which is the term in Thai] opener instantly stops operating properly, the reason for the trouble is typically quite basic to comprehend, and the remedy is generally quite simple.
Here are a few most common problems, in addition to the most likely fixings for each and every. If none of the adhering to repairs seem to remedy the problem, you will require to consult the proprietor’s guidebook or get in touch with a specialist.
- Neither Push-button Control nor Wall Surface Switch Operates the Opener
When the garage door didn’t budge at all when the remote or wall surface switch pressed, it’s practically certain the source of power has been interrupted in some way:
Just like numerous such troubles, one of the most common problems is the simplest one; the electric motor system has been unplugged. Begin by inspecting the outlet where the door opener is connected, and ensure the cable is connected in all the methods.
- Garage Door Will Not Reply to Remote or Keypad
There are numerous possible solutions when a cordless remote or installed keypad stops running the opener:
Relocate closer to the door. It’s possible you are out of range of the antenna inside the garage. Modern garage door openers are basically small radios that run at about 315mH, as well as a couple of feet of additional range can influence the signal.
- Garage Door Will Not Close All the Way
If the garage door opens up correctly yet falls short of shutting entirely, there might be just one of three common reasons:
The close-limit switch may need adjusting. Your garage door has set-limit buttons that instruct the electric motor when to stop running, both when it is opening, as well as when it is shutting. If the close-limit switch is established incorrectly, it may protect against the door from closing. It can also create the opener to reverse or draw back up when you attempt to shut it.
